Visual Productions forum
Products => Cuety & LPU => Topic started by: Herzelius on May 20, 2015, 10:27:51 AM
-
I recently got a Cuety LPU-1 controller and was about to upgrade from firmware version 1.00 when something went wrong.
At the moment i cannot reset the unit to factory defaults or erase the stored data. I have waited for over 30 minutes for something to happen.
I need to get this thing working until friday. Any suggestions?
(http://s23.postimg.org/afg4b5a3r/firmware_problem.jpg) (http://postimg.org/image/afg4b5a3r/)
-
Oh dear, this doesn't look right :(
I would try a power-cycle, hopefully you can do the firmware upgrade again.
If the LPU stays like this then I am afraid you need to contact your supplier to see if they can send it back to NL for a low-level re-program of the firmware.
Just for us to learn from... can you explain what happened during the firmware upgrade?