Visual Productions forum

Products => CueCore, QuadCore, IoCore, TimeCore & B-Station => Topic started by: Tyler Ferrero on November 11, 2016, 07:48:24 PM

Title: OSC send command URI issue
Post by: Tyler Ferrero on November 11, 2016, 07:48:24 PM
Hello,

I am using a cuecore2 to drive an event that involes a lot of time of day triggers. So the tech can operate it, I made a touchOSC interface for the unit. Getting button commands to send from the controller to the cuecore2 works well, but getting cuecore2 to send data back is an issue. When attempting to manually type in the OSC URI, or copying and pasting the address, the '/' symbol is turned into '19'. This does not allow the touchosc controller to receive the data to the correct page. See attached for what happens when you type or copy the address in. It should be '/DSCTT = Show/DAYLED'

When setting the OSC command for Cuecore2 to learn (such as for osc commands being received from cuecore2) it puts the correct address in.
Title: Re: OSC send command URI issue
Post by: Guido Visser on November 15, 2016, 11:26:04 AM
Hello Tferr,

Thank you for reporting a bug to us. This is a bug which is only in firmware 1.07. We will be working on removing this bug.

I will send you a personal message to discuss this.

Best regards,
Guido