Visual Productions forum
Products => CueCore, QuadCore, IoCore, TimeCore & B-Station => Topic started by: alefur on November 15, 2017, 01:14:45 PM
-
Hi,
simple question, wich TCP or UDP port is used to discover the Cuecore2 with vManager software or with CueluxPro to see Cuecore who are connected?
Is it a special protocol or only a simple known one with a dedicated port used on it?
Best regards
Anthony
-
Hello Alefur
There are two systems used to discover a unit. One is a broadcast message from the CueCore2 to port 16945. And the other is a broadcast message from the vManager and CueluxPro to port 16945. Which the CueCore2 then response to with a unicast message. All messages are UDP messages.
May I ask what you are trying to create?
Best regards,
Guido
-
Hello Guido,
thanks for your answer.
I'm trying to setup a VPN network with few cuecore and 4G/LTE router over a city but I need to unlock this port on the firewall if I want to monitor all the cuecore from a central site with vManager or Cuelux Pro.
We already have 4 cuecore connected on a city and the next step is to interconnect them to receive udp message from a central site and start the same scenario in the same time.
I will try to continue with your informations.
Best regards
-
Hello Alefur
That sounds like an interesting project. Good luck!
Best regards,
Guido
-
Hello Guido,
is it possible to add an option on Cuelux Pro and vManager to manually discover/search the networked devices?
I have this option on other controler and I can manually add with an IP address or a dyndns address to be connected to remote devices.
Do you know what I mean?
That will allow Cuelux Pro or vManager to be controlled easily over the internet network instead of being connected on local network.
Best regards
-
Hello Alefur
We have that functionality on the wish-list. However we do not have a date when we will add it.
Best regards,
Guido