Visual Productions forum

Products => CueluxPro => Topic started by: d_bright on November 28, 2017, 03:51:50 PM

Title: Problem with dumping cuelist to QuadCore track
Post by: d_bright on November 28, 2017, 03:51:50 PM
Hi,

I’m trying to dump dynamic effects (rotating gobos mapped to a series of RGB festoons) to a track on a quad core. However, no matter what I do it either says the recording is too large, or records a section after the effect where all the fixtures are at 0 and not as a seamless loop. I’ve followed the manual but it doesn’t say anything about how you specify track lengths when dumping.

Any ideas?

Thanks,

Danny
Title: Re: Problem with dumping cuelist to QuadCore track
Post by: Michael Chiou on November 29, 2017, 08:51:55 AM
Hello @ d_bright,

Could send us your showfile and tell us your QuadCore firmware version and CueluxPro version?

Greetings,

Michael.
Title: Re: Problem with dumping cuelist to QuadCore track
Post by: Zoë Castle on December 04, 2017, 11:28:25 AM
We supported Daniel by phone with this, and advised for the memory to be divided differently so the tracks were larger size.

 We hope your customer demonstration went well!

Greetings Zoë