Visual Productions forum
Products => CueluxPro => Topic started by: AxelF on February 21, 2018, 10:51:26 PM
-
Hi,
I want to connect an Eurolite Node1 via Art-Net to CueluxPro..
The Node1 is configured to 10.0.9.5, Universe 1.
I can send values via the Entec Node Management Utility NMU if I select universe 0.0. It works well.
Unfortunately it does not react on CueluxPro. There I have configured the second part of the Cuecore also as Art-Net Output. The packages look similar to the packages of the NMU, but the port address is different.
Can I Setup a third universe over the Art-Net ?
Is anybody familar with the configuration ? I have installed Wireshark on the computer…
Regards
Axel
-
Hello @AxelF,
So to understand your question better, you have a CueCore you are already using 2 Art-Net universes and you want to use a 3rd one?
Greetings,
Michael.
-
Morning Michael,
I have a Cuecore with one universe used. The second is free.
Must I connect the Art-Net to the second universe ?
Regards
Axel
-
Hello @AxelF,
Yes the for each CueCore Universe you get an Art-net universe. Is it a CueCore1 or a CueCore2? So for example if there isn't an outlet connected to that art-net universe CueluxPro will not send art-net.
Greetings,
Michael.
-
Michael,
ok, I understand, but it does not work anyway.
Is there anything I can configure at that Art-net output other than the Ip address and the universe ?
Regards
Axel
-
Hello @AxelF,
Could you send us your showfile?
Greetings,
Michael.