Visual Productions forum

Products => Cuety & LPU => Topic started by: EVDV on November 12, 2018, 02:22:55 PM

Title: problem with my PB performance with Cuety LP-2 and TouchOSC
Post by: EVDV on November 12, 2018, 02:22:55 PM
my STOP button in TouchOSC only releases the button commands and not the faders.
 the programmed buttons works perfect on/off and if I push the STOP button in my TouchOSC layout all the programmed cues (on/off) are stopped - release all, but the cues who are placed under de faderbuttons (0-100%) don’t stop with this command, could not been released with that  release all (stop) button. It is possible that it has to do with the solution of my earlier question that you solved regarding the working of the faders-dimmers in the TouchOSC.

 I tried to change the playback19 to a simple on:off switch as the 9,10,11,12 PB, and 17,18,19 PB buttons should been programmed. But I did something wrong, I wanted to check how to proceed and how PB18 was programmed But I did something wrong because I copied PB19 on PB18 instead.t. So I have to change PB18 and 19 to a simple on/off commando. The colorfaders RGB on 13+14+15 are never in use. It has to be simple 5 fader/dimmers and 7 buttons on/off.

I’ll try again.
Title: Re: problem with my PB performance with Cuety LP-2 and TouchOSC
Post by: Bootsy van der Zande on November 13, 2018, 11:22:36 AM
Hi,

I'm not sure I understand completely what you want, is it to set al faders at 0% or 100% when releasing?

The release all command is either /release or /pbxx/rel.
To set al intensity you can use a float value between 0 and 1 with OSC command /pbxx/int
Hope that helps! If you have more questions, feel free to ask.

Greetings,
Bootsy
Title: Re: problem with my PB performance with Cuety LP-2 and TouchOSC
Post by: EVDV on June 29, 2019, 03:58:36 PM
My problem still exist: The first five channels are dimmer function that work very good now but the release command works only on the programmed on/off buttons and the dimmers stay on, are not influenced by the stop/release function button. (the command should be 100% > 0%

Somebody help ?  BUT SEE ALSO MY NEW ISSUE.
Title: Re: problem with my PB performance with Cuety LP-2 and TouchOSC
Post by: Bootsy van der Zande on July 01, 2019, 10:19:31 AM
Hi,

Whats the properties set on these faders that are not releasing? Release all is something different than set all faders to 0%.

Greetings,
Bootsy
Title: Re: problem with my PB performance with Cuety LP-2 and TouchOSC
Post by: EVDV on July 01, 2019, 04:41:48 PM
The release all should be able to set all dimmers to zero and the buttons on/off to OFF.
Is that possible?
Title: Re: problem with my PB performance with Cuety LP-2 and TouchOSC
Post by: Bootsy van der Zande on July 01, 2019, 05:39:45 PM
Hi,

I'm afraid that it's not possible in a single command.
You can make two buttons for it, one sending release all and one sending all faders to zero.
The commands are:

/pbxx/rel
/pbxx/int with the value 0

Greetings,
 Bootsy