Visual Productions forum

Products => CueCore, QuadCore, IoCore, TimeCore & B-Station => Topic started by: c2b on October 23, 2020, 10:01:03 PM

Title: [HELP] Timespan
Post by: c2b on October 23, 2020, 10:01:03 PM
Hi,
(Couldnt find any topic on the subject)

I have been trying to use timespans in a few installations, yet without luck.

I want to use the timespans to define opening hours for installations.

From my understanding of the manual explanation, my use case should be possible with the config in attached file
I have not been able to get any triggers from timespan using full wildcard date entries (xxxx-xx-xx), I have had mixed results (occasional trigger) by specifying full dates (2020-10-23).

Could you please advice?
Thank you again for your help
Title: Re: [HELP] Timespan
Post by: Bootsy van der Zande on October 26, 2020, 09:26:08 AM
Hi,

Strange, at first glance it seems that should work. Which firmware version are you on? I do remember some older firmwares not responding outside of the timespan, only inside. But that was fixed I believe.

Perhaps you could send me a backup of the CueCore2 and I will have a look.

Greetings,
Bootsy