Visual Productions forum
Products => CueCore, QuadCore, IoCore, TimeCore & B-Station => Topic started by: Manu608 on November 05, 2020, 04:08:17 PM
-
IHello !
I was wondering is there a way to do a pause on a playback and then when a command is send the show will go where we pause it ?!
Thank you
-
Hi,
On which device do you want to do this?
On the CueCore2 and QuadCore you can use the task "Playback - Transport - Pause" to pause the cue (and thus track). A simple Go+ (Playback - Transport - Go+) will continue where it left of.
Be careful though, the "Execute" button in ShowControl does not take into account the Triggerflank. Pressing it will do a Go+ twice, so you end up in the next cue...
Using an OSC(or other) command with the Triggerflank set to "Down" or "Up" should work fine.
Greetings,
Bootsy
-
Hi
On a quadcore, I will be using UDP signal to do. I couldn't test it yet but I was wondering if it will work with a transport then a Go+ but i will try it this week and let you know
Thank you
-
Hi,
It should work. I ran into the issue with the execute button the other day when trying exactly this. Once I figured out my mistake (whoops) with the execute button, it worked fine.
Greetings,
Bootsy