Visual Productions forum

Author Topic: Moving head 'Home' position  (Read 1941 times)

September 02, 2010, 12:19:54 AM
Read 1941 times

Rayco

  • Member
  • *
  • Posts: 276
Hi Maarten,

Is it possible to set a default 'home' position for a moving head?

Rather than it default to a position where it is miles away from where you will be using it., can it be set to, say, 127,127

This would leave it pointing straight up ready to move to any position.

Thanks

September 02, 2010, 09:14:24 AM
Reply #1

Bart van Wunnik

  • Member
  • *
  • Posts: 221
    • CompYouServ
Hi Rayco,

Unfortunately this is not possible within Cuelux.
Bart van Wunnik


September 02, 2010, 09:20:43 AM
Reply #2

Julien Levaufre

  • Administrator
  • Member
  • *****
  • Posts: 3182
    • www.visualproductions.nl
hum, on my side when i use mooving head with cuelux the start point is always in the middle of the grid so it's 127/127... :-\
Julien Levaufre
Visual Productions BV

September 02, 2010, 09:45:40 AM
Reply #3

Rayco

  • Member
  • *
  • Posts: 276

Was test fixures out tonight and found they do 'home' to 127,127

Silly me....

« Last Edit: September 02, 2010, 11:17:17 PM by Rayco »

 

SMF spam blocked by CleanTalk