Moving head 'Home' position

[Rayco]

Hi Maarten,

Is it possible to set a default 'home' position for a moving head?

Rather than it default to a position where it is miles away from where you will be using it., can it be set to, say, 127,127

This would leave it pointing straight up ready to move to any position.

Thanks

[Bart van Wunnik]

Hi Rayco,

Unfortunately this is not possible within Cuelux.

[Julien Levaufre]

hum, on my side when i use mooving head with cuelux the start point is always in the middle of the grid so it's 127/127...

[Rayco]

Was test fixures out tonight and found they do 'home' to 127,127

Silly me....