I'm back again....
Yesterday it was the first time that I used CueLux with some live bands on stage
In a small time I programmed some easy effects to our RGB-pars on stage...
We also used two extra six-bars to get more impact.
For the six-bars I programmed some chases.
Just one point...
The fader-start function will not work all the time in combination with the BCF2000 !
Sometime the auto GO-function didn't trigger GO, the fader-feedback is no problem and is always 1:1.
I now it's a small area to give the GO-info to CueLux... (otherwise there is all the time a GO-triggering)
Is it possible to make the first Q in that playlist more safe, so it always go's active when you move the fader Upwards ?
(basically I only use a fader-start when I have one Q in that playlist)
When there are more Q's stored in that playlist...
As long the fader is between level 1 and 127 only Q-1 can be activated...
(When Q-1 already is active, there is no GO anymore when you move the fader Upwards.)
When the fader stays at level 5 and you moved the fader Upwards and Q-1 is in-active, then Q-1 will be activated...
When you pressed the GO-button, the playlist go's to Q-2...
When Q-2 ore higher is active, Q-1 can't be activated anymore by fader, until the playlist is released again.
I hope you understand what I mean, otherwise I will sent you a PM in Dutch
To come back on my last post...
If I will use Qlab safe (on this moment), I have to change the personality from our RGB-pars...
For each RGB-par I will use a generic 3-dimmer pack personality... (don't need all the functions, see code)
This all makes it possible, that I can use the fader-start option...
(when I use the fader-start option with the normal personality... there is a problem with the color-change between different playlists...[HTP/LTP problem]
Also the LTP-function doesn't solved this problem)
A dimmer output-level is also depend from the fader position.
This makes it possible to make a better cross-fade between different playlists, without a hard color-change.
Here the generic personality code:
fixture "RGB-par"
mode "mode-5"
{
sub
{
dimmer msb 0 0,255
}
sub
{
dimmer msb 1 0,255
}
sub
{
dimmer msb 2 0,255
}
preset 3 0
preset 4 255
preset 5 0
}
preset 3 0
This is normally the Strobe-function and is now disabled.
preset 4 255
The main-dimmer function is now always set to 255.
preset 5 0
This is normally a effect and is now disabled.
With Qlab I can now use the fade-in to move the fader Upwards, or a fade-out to move the fader Downwards..
This is more safe than a GO-function.
When we have a live-band, then I will open a other show-file.
In this show, all RGB-pars are patch with the normal Ignition personality.