Visual Productions forum

Author Topic: Upgrade to firmware v1.04  (Read 11635 times)

January 19, 2007, 03:24:07 PM
Read 11635 times

Zoë Castle

  • Visual Productions
  • Member
  • **
  • Posts: 288
    • http://www.visualproductions.nl
This notice applies to DMX Output devices with PCB version 1.00.

When using VisualDMX 1.46 or later, it is advised to upgrade your DMX Output's firmware to v1.04.

How to check your device's firmware
When connected to VisualDMX, go to the Options windows (accessible via 'Tools' menu) and open the 'DMX Hardware' tab. This screen will indicate the connected devices with their PCB and firmware versions.

How to upgrade the firmware
For this specific device, the firmware is upgraded by conducting the following steps:
1. Exit VisualDMX and disconnect any DMX Output
2. go to the following directory 'c:\Windows\System32\Drivers'
3. if the date of the file 'outputldr.sys' is older than 8-2-2006 it needs replacing.
4. replace the file by the one located in '\Program Files\Visual Productions\VisualDMX\Drivers'
5. Connect the DMX Output and start VisualDMX. Check the firmware again to verify the new version.
Zoë Castle
Sales Manager
Visual Productions BV

June 25, 2007, 09:02:50 AM
Reply #1

Maarten Engels

  • Administrator
  • Member
  • *****
  • Posts: 2383
    • www.visualproductions.nl
Above post is intended for DMX Output MKI users only!
Maarten Engels
Visual Productions BV

 

SMF spam blocked by CleanTalk