Hi forum,
I have just received my ADJ TriBar Spot. In the past these bars were a pain to control with Cuelux.
Now with CueluxPro I can use the matrix function.
1.) I have added the unit in the patch window - 20 channel mode. I have put it to dmx address 353.
2.) Controlling it from the status windows works fine, even if the subfixtures are difficult to select with the finger.
3.) I have added this fixture at matrix-layout, turned by 270° and have set a matrix size of 6 x 1.
4.) In the matrix-pattern I have done nothing.
5.) in the matrix-layer I have added a layer with a size of 6 x 1
Now I have a new unit in the fixtures windows on the first position. If I select it, I have a lot of options in the bottom right window.
No matter what I do, the dimmer channel of the fixture (dmx 372) doesn't output anything other than 0.
Instead the dmx addresses 5, 6, 7, 8 output the R,G, B and dimmer values.
Any ideas ?
Regards
Axel