CueCore - Showcontrol and recorder problem:

[pieter.decoster]

Hello,

I cannot trigger more than 4 recorder cues at the same time

In our radio studio we have several lights.
We have a led strip for the wall with a fixed color (goes on when power UP). (Recorder n°3)
There is also one small ledstrip in de the same color, that changes to RED when Microphone is on. (n°1&2)

In the studio there are multiple light (DJ, sidkick, guest, band, ...)
Fore thes light i've made also several recorder settings (n°s 7-13).

Thus, begin with start up. Recorder ID's 1 & 3 are ON
Whith the B-station, I activate for example n°6&7.
That works fine.
Then I trigger with one UDP multiple Recorder ID's: 8 thru 13 only 10 thru 13 goes on AND n°s 1,3,6&7 goes OFF.

To continue, I open my Microphone fader, so Recorder n°2 is activated and appearently n°10 goes off.
I close my Mic fader now: n°1 goes back on as it should, but n°11 goes off and n°s 12&13 stays ON.

That was not what I expected. What goes wrong or what did I do wrong in my configuration?
It is difficult to make a working configuration as we wanted.
Can somebody help me whith that problem.

Thank you,

Pieter De Coster

[Zoë Castle]

Dear Pieter

This is correct.  You can trigger up to 4 recorder memories at one time in the CueCore.

A way to give you more actions at one time, which I think sounds very possible for your situation, could be:

For static cues such as that you have in Recorder 3 now:
You can trigger simple DMX values direct via the show control.

Plus 1 Cue from the CueCores console
Plus 4 recorded memories

I hope this makes sense, you are welcome to email me with more details if you need further advise:  zoe "at" visualproductions "dot" nl

Met vriendelijke groeten Zoe