Something went wrong during firmware upgrade...

[Herzelius]

I recently got a Cuety LPU-1 controller and was about to upgrade from firmware version 1.00 when something went wrong.
At the moment i cannot reset the unit to factory defaults or erase the stored data. I have waited for over 30 minutes for something to happen.

I need to get this thing working until friday. Any suggestions?

[Maarten Engels]

Oh dear, this doesn't look right 

I would try a power-cycle, hopefully you can do the firmware upgrade again.
If the LPU stays like this then I am afraid you need to contact your supplier to see if they can send it back to NL for a low-level re-program of the firmware.

Just for us to learn from... can you explain what happened during the firmware upgrade?