Visual Productions forum

Author Topic: Something went wrong during firmware upgrade...  (Read 1236 times)

May 20, 2015, 10:27:51 AM
Read 1236 times

Herzelius

  • Member
  • *
  • Posts: 1
I recently got a Cuety LPU-1 controller and was about to upgrade from firmware version 1.00 when something went wrong.
At the moment i cannot reset the unit to factory defaults or erase the stored data. I have waited for over 30 minutes for something to happen.

I need to get this thing working until friday. Any suggestions?


May 21, 2015, 05:59:43 PM
Reply #1

Maarten Engels

  • Administrator
  • Member
  • *****
  • Posts: 2383
    • www.visualproductions.nl
Oh dear, this doesn't look right  :(

I would try a power-cycle, hopefully you can do the firmware upgrade again.
If the LPU stays like this then I am afraid you need to contact your supplier to see if they can send it back to NL for a low-level re-program of the firmware.

Just for us to learn from... can you explain what happened during the firmware upgrade?
Maarten Engels
Visual Productions BV

 

SMF spam blocked by CleanTalk