Visual Productions forum

Author Topic: MIDI Clock from a DAW doesn't work  (Read 2273 times)

October 29, 2015, 09:23:23 PM
Read 2273 times

atum_y

  • Member
  • *
  • Posts: 2
Hi everyone,

I recently started working on an automated light show for a band. As the band uses Reaper to run backing tracks and in-ear monitoring, I synced up the light-show via MIDI in the DAW which then sends it to Cuelux. However the MIDI clock doesn't reach Cuelux somehow. I used a MIDI monitoring programmto check the inputs and outputs and the clock signals do reach the input that leads to Cuelux, but the clock in Cuelux doesn't switch from automatic to MIDI.
I am using a Mac and, as mentioned, Reaper. As a bridge between Reaper and Cuelux, I use an app called "MIDI Patchbay". But I don't think the problem is in these because the monitor shows the cock signal in the input device and the control messages do reach Cuelux.

Thanks in advance for the help!

October 30, 2015, 08:17:56 AM
Reply #1

Julien Levaufre

  • Administrator
  • Member
  • *****
  • Posts: 3234
    • www.visualproductions.nl
the switch between manual and midi is not automatic. you need to click on the bpm counter and hold to switch. ;)
Julien Levaufre
Visual Productions BV

October 30, 2015, 08:58:34 AM
Reply #2

atum_y

  • Member
  • *
  • Posts: 2
Now I feel stupid for overseeing that in the manual. Thanks a lot though! :)

October 30, 2015, 09:42:14 AM
Reply #3

Julien Levaufre

  • Administrator
  • Member
  • *****
  • Posts: 3234
    • www.visualproductions.nl
Julien Levaufre
Visual Productions BV

 

SMF spam blocked by CleanTalk