Visual Productions forum

Author Topic: One CueCore -> Multi Visualtouch  (Read 3895 times)

April 24, 2016, 08:06:03 AM
Read 3895 times

David C

  • Member
  • *
  • Posts: 13

Hello there,

Not tried yet, could it be possible to have (in same network) two or more Visualtouch (clients)
to drive the same CueCore (server), with the same interface I guess..?

Thnxs.

April 28, 2016, 06:28:10 PM
Reply #1

JurriŽn de Klerk

  • Visual Productions
  • Member
  • **
  • Posts: 94
Hello David,

Just did a small test, yes this is possible. There is no feedback between the different VisualTouch servers.
Best regards,

Jurrien
JurriŽn de Klerk
Visual Productions BV

June 10, 2016, 05:07:12 PM
Reply #2

JustinD16

  • Member
  • *
  • Posts: 1
How did you have it set up. I have my cuecore on a switch and cuelux pro sees it and runs but i can't get visual touch to control it. When I connect the cuecore directly into the macmini visual touch works fine, but I can't get visual touch on another machine to connect. thoughts? what am I doing wrong?

June 15, 2016, 05:08:21 PM
Reply #3

wanderxxx

  • Member
  • *
  • Posts: 9
Hey Justin,

Do you want to control Cuelux Pro or the cuecore from multiple visualtouch locations?

If you want to control Cuelux Pro you need to make a actionlist under actions.
Then in Visual touch type in the ip adres from the machine were cueluxpro is running or push scan for servers. And select the action list from CueluxPro
On the second machine start visual touch and repeat the above.

If you want to connect the cuecore. Go to the ip adres from the cuecore and create an actionlist for visualtouch.
Then on the first visual touch push scan for servers en select the actionlist from the cuecore
On the second machine start visual touch and repeat the above

I hope with this you get it working

Regards

Wander

 

SMF spam blocked by CleanTalk