Visual Productions forum

Author Topic: Best practice to disable/enable GPI on DMX input and how to set a range for dmx?  (Read 886 times)

October 27, 2016, 12:52:06 AM
Read 886 times

jms

  • Member
  • *
  • Posts: 3
What is best practice for the CueCore1 when:

1) disabling recordings run by GPI when DMX input is detected?

2) enabling GPI functions again when no DMX input is detected?

3) setting a min (e.g. 30 out of 255) and max output (e.g. 200 of 255) value for the dmx output, when recording is controlled by a dmx input?

Thanks,

 - John

October 27, 2016, 09:49:04 AM
Reply #1

Guido Visser

  • Administrator
  • Member
  • *****
  • Posts: 228
    • Visual Productions
Hello John,

1 and 2)
In the DMX In action list there is a trigger called Receiving.
This generates a up and down flank when dmx is received or not received.
Using one of these flanks per action will allow you to enable or disable the action list GPI.
You may also have to stop all recordings activated by the GPI.
This is done by changing the playstate of a recording.

3)
You can limit the max output of a recording using the intensity.
There is no way of specifying a minimum value.

If you need live throughput from DMX in to DMX out.
There is a way to limit the maximum, however this is limited to 5 channels using the console and 4 recordings.
If you set the console / recording to output 200 on one channel and control the intensity using the DMX in.

Best regards,
Guido
Guido Visser
Visual Productions BV

 

SMF spam blocked by CleanTalk