Hello Guido,
I have a big issue with this configuration.
First, I give you more informations about the configuration and about the issues we meet on a second time.
We have 1 Cue Core, 1 splitter(ENTTEC raildin), few LEDs driver.
DMX output 3 is controlling 5 RGB drivers
DMX output 4 is controlling 6 RGB drivers (DMX address begin at 413)
My first issue is the DMX control of the products.
When I use the manual control with a track on my Cue Core, DMX address is not answering at the good address.
If I hit 413 AT Full, the DMX address is at Full but my projector is not at Full
If I hit 416 at Full, then, my projector is at full.
I don't understand why I have this DMX offset of 3 address.
If I try the same test with another DMX controler (Martin M-PC, Pharos LPC1), I don't have this issue, I can control my drivers at 413...
My second issue is:
When I send a value to this drivers with a fade value (I'm always using a DMX splitter), I have a flickering issue on few projectors.
This flickering is worst if I create a cuelist who is turning ON each projectors one by one with a fade value.
If I create the same sequence with aother controler, I don't have this issue.
I've tried to change the Cue Core with a new one and make a new configuration but I have the same issues.
I can send you a backup of my configuration if you want.
We can communicate by mail about this if you prefer.
PS: in the same city we already used this LED drivers with no issue, the only difference is the DMX who begin at 1.
PS: I've tried the slow DMX option with no changes