Hello Edvin,
Im building an interactive installations with 11 sensors,
That sounds like a fun project.
they will each trigg CUEs on PB 2
Ok. Sounds good.
PB 1 will be faded in and out with these cues.
Faded in and out with which cues? The cues of Playback 2? You can not fade a playback with the cues of another playback.
I assume you are using a number of CueCore2. And that you want some light effect to be shown when someone interacts with the setup. Which will fade out when the interaction stops. This kind of behavior will take a playback for every effect.
Please tell me which of our products you use.
In case I did not understand you goal correctly a basic GPI to playback example.
If you have connected every sensor to a GPI port. You can use two actions to start and stop a cue of a playback.
1. On the show control page add the source GPI.
2. Add an action to the GPI actionlist.
3. Set the trigger type to Channel.
4. Set the trigger value to the GPI you use.
5. Set the trigger flank to Down.
6. Add the task "Playback -> Jump -> Set" to the action.
7. Set param 1 to the playback index.
8. Set param 2 to the cue number.
9. Add another action to the GPI actionlist.
10. Set the trigger type to Channel.
11. Set the trigger value to the GPI you use.
12. Set the trigger flank to Up.
13. Add the task "Playback -> Transport -> Release" to the action.
14. Set param 1 to the playback index.
15. Repeat Step 2 trough 14 until you have configured all GPI ports.
Best regards,
Guido