General UDP message to be programmed to CUECORE 1

[marijnbosman.mb]

Hi,

I want to program an action (set a recorder to intensity) with a UDP message from an external message on the CueCore 1.

The Wireshark overview from a message is:
0000   01 00 5e 00 00 01 a0 1e 0b 0b 51 85 08 00 45 00   ..^... ...Q...E.
0010   00 32 0b 56 40 00 01 11 c6 57 c0 a8 01 64 e6 00   .2.V@...ÆWÀ¨.dæ.
0020   00 01 11 5d 11 5e 00 1e e6 d4 00 00 00 00 00 00   ...].^..æÔ......
0030   00 00 00 00 4c 13 01 00 00 00 01 00 00 00 00 01   ....L...........

Can you tell me what I have to program on the CUECORE1?

The player will send this message not specific to the player IP, but general.

[Bootsy van der Zande]

Hi,

Have you tried the "Learn" option? You do have to set the right UDP port, as I see this Wireshark message is on 4446.

What device are you sending from? Is there anything that can be setup.

Greetings,
Bootsy

[marijnbosman.mb]

Yes i tried. Port is set correct. But the player will nit send a message direct to the cuecore ip, but to the whole network.

The learn option didn’t receive as long as i didn’t send specific to the cuecore1 ip.

[Bootsy van der Zande]

Hi,

I'm afraid that if the learn function doesn't receive it, the rest of the CueCore doesn't either.
Have you checked the monitor page for the UDP message?

Greetings,
Bootsy

[marijnbosman.mb]

Can the CueCore1 set to listen to a multicast between 224.0.0.0 & 239.255.255.255

[Bootsy van der Zande]

Hi,

I'm afraid it doesn't. The currently doesn't have the option to listen to a certain Multicast IP address, so the switch doesn't forward the UDP messages.

Greetings,
Bootsy