dmx and artnet

[janbosko]

it is possible to transmit a trigger signal via the 'GPI' inputs. I want to control resolume via DMX, via artnet ....
I use a cuecor2 and culuxpro software, but I can not send dmx signals via artnet. If you send a dmx signal via the dmx plug to the cuecor2, is that also sent via artnet?
Is this possible and how should I set it up.

thanks Jan.

[Guido Visser]

Hello Jan,

Depending on if you are using CueluxPro live or just to program the CueCore2 you will have to do one of the following.

When using CueluxPro live.
1. Open the Memories screen.
2. Open the Action screen.
3. Add a GPI actionlist.
4. Set the Identifier to the IP address of the CueCore2.
5. Add and edit an action.
6. Set the trigger to select the pin of the CueCore2 you want to use.
7. Add a task DMX.
8. Set the feature to Set Value.
9. Set the function to Control.
10. Change parameter 1 to the universe and channel.
11. Open the Patch screen.
12. Open the universe screen.
13. Enable Art-Net output.

When using the CueCore2 in stand alone mode. (Using CueluxPro to programming but not live)
1. In the web interface of the CueCore2.
2. Open the show control page. (Maybe you will have to close CueluxPro to get access to the page.)
3. Add the actionlist GPI.
4. Add and edit an action.
5. Set the trigger to select the pin of the CueCore2 you want to use.
6. Add a task DMX.
7. Set the feature to Channel.
8. Set the function to Control.
9. Change parameter 1 to the universe and channel.
10. Open the settings page.
11. Enable the Art-Net output.

I hope this helps you.

Best regards,
Guido