Hello,
I want to control a Christie projector and an Atlona video switch using RS232 with an IoCore, I've been trying a lot, but it doesn't work.
What I have:
Visual Productions IoCore2
Atlona SW-52ED 4K/UHD Five-Input HDMI Switcher
Christie DWU599-GS projector
I've been testing the devices separately from each other by wiring the RX to the TX port en the TX to the RX port. And off coarse the ground to the ground.
The settings in every device are the same:
Serial Port Baud Rate: 115200
Serial Port Echo: off
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
For example I'm sending the following messages from the IoCore:
RS232, Send String, Set
To the projector:
Param1: (PWR 1)
Param2: 5
(what does Param2 do?)
To the switch:
Param1: PWON
Param2: 4
In the IoCore monitor I see the command has been send, but the projector as well the switch won't respond on my actions.
Do I need to send an start command, or maybe I've to separate it in more than one command?
In the attachment you can find the documents off the projector and switch.
What am i doing wrong? Can someone please help me!