Cuety LPU-2 does no longer listen to my programmed Touch OSC

[EVDV]

After my former problems the LPU-2 world for 1 1/2 year perfectly with my TouchOSC layout on my IPad. I had to change my IPad to a newer version and everything worked for more than a year perfect, although I had to adjust the IP adres often from 196.XXX.X.189 to 190 or 188...but everything was working.
Now suddenly the CuetyApp works perfect but the Touch OSC commands are not working at all. What can be wrong? I checked the values and I even used my old IPad again, but this didn't change a thing. I resented all my Router, Acces points, in cascade (Apple) and so on. This happened after a "internet" drop of my provider (router Orange). Can somebody help me please.

Best Regards,

Erwin

[Bootsy van der Zande]

Hi Erwin,

Are you sure the IP settings are right? Perhaps your LPU changed IP because of the DHCP server of your router being down.
Make sure that the IP target settings match that of the LPU's IP address.

You could use vManager to check the IP of your LPU, and check if you have the most recent version of firmware.

Greetings,
Bootsy

[EVDV]

Hi Bootsy,

I checked and installed the latest V-Manager and I had to update my LPU-2 to 1.22. That is done and running. I checked the IP adres in my TouchOSC and that is OSC: 192.168.0.190 and the V-Manager also give me 192.168.0.90 so I changed and everything is working perfect again. There is only stil the fact that the command under my STOP button in TouchOSC do release only the on/off buttons but not de value of the dimmers to zero. That I have to by using the slider button to 0. See my other issue on the post.
Anyway,

Many Thanks in resolving my question so I could see that the IP adres was not correct in the TouchOSC App.

Best regards,

Erwin

[Bootsy van der Zande]

Hi Erwin,

Glad it's working again.
I also replied to your other post.

Greetings,
Bootsy