Products > Kiosc
Using UDP float
greg-pulse:
I need to send commands
"CSQ 1 <float> \r"
to my Symetrix Composer device with Float between 0 and 65535
I am able to use packet sender and control my device but entering
"CSQ 1 "
into the Kiosc editor UDP tag, with the Kiosc setup with the right IP and Port but this doesn't work.
I have setup the min and max values.
Not sure how to put the float in the right place and make sure I have a <CR>.
Bootsy van der Zande:
Hi,
It is currently not possible to send a <CR> after the float value.
As a workaround, you can try to put the <CR> in front of the UDP Message.
This way you would send
\rCSQ 1=57579.86
\rCSQ 1=57579.87
\rCSQ 1=57579.88
Otherwise I'm guessing you can't use it until we implement the <CR> value.
This is the downside of UDP over OSC, with UDP every manufacturer does it differently... OSC is standardised.
I'm very sorry for the inconvenience.
Greetings,
Bootsy
greg-pulse:
Thanks for the reply Bootsy.
Is there any way to turn off the decimal and only send whole numbers?
Bootsy van der Zande:
Hi,
You can set the fader to 'Unsigned integer' instead of 'Float'. This should make it send whole numbers instead.
Greetings,
Bootsy
greg-pulse:
Hi,
Doing this is will only give me a bootlean, 0 or 1. as per the attached
Navigation
[0] Message Index
[#] Next page
Go to full version