Visual Productions forum

Author Topic: Timecore Display  (Read 637 times)

December 24, 2019, 04:46:47 AM
Read 637 times

Jpullen

  • Member
  • *
  • Posts: 1
Is there a OSC command that will display a time stamp. Ive got commands to start, stop, pause and change the time stamp. What I would like to do is after stopping, timecode, which displays “stop”, and then I send a new time stamp. Be able to see the new time stamp, instead of  “stop”.
Thanks

January 02, 2020, 05:28:15 PM
Reply #1

Guido Visser

  • Administrator
  • Member
  • *****
  • Posts: 227
    • Visual Productions
Hello Jpullen,

If you do not want TimeCore to display start, pause or stop. You can remove the corresponding action from the Timecode actionlist in show control.

If you want to display a specific message on the display. You can use the task "System -> Display -> Set" with a custom message.

I hope this helps you.

Best regards,
Guido
Guido Visser
Visual Productions BV

 

SMF spam blocked by CleanTalk