Visual Productions forum

Author Topic: Showcontrol and Pause  (Read 40 times)

November 05, 2020, 04:08:17 PM
Read 40 times

Manu608

  • Member
  • *
  • Posts: 56
IHello !


I was wondering is there a way to do a pause on a playback and then when a command is send the show will go where we pause it ?!


Thank you

November 05, 2020, 06:32:52 PM
Reply #1

Bootsy van der Zande

  • Administrator
  • Member
  • *****
  • Posts: 366
Hi,

On which device do you want to do this?

On the CueCore2 and QuadCore you can use the task "Playback - Transport - Pause" to pause the cue (and thus track). A simple Go+ (Playback - Transport - Go+) will continue where it left of.

Be careful though, the "Execute" button in ShowControl does not take into account the Triggerflank. Pressing it will do a Go+ twice, so you end up in the next cue...

Using an OSC(or other) command with the Triggerflank set to "Down" or "Up" should work fine.

Greetings,
Bootsy

November 05, 2020, 06:53:46 PM
Reply #2

Manu608

  • Member
  • *
  • Posts: 56
Hi

On a quadcore, I will be using UDP signal to do. I couldn't test it yet but  I was wondering if it will work with a transport then a Go+  but i will try it this week and let you know


Thank you


November 06, 2020, 09:52:11 AM
Reply #3

Bootsy van der Zande

  • Administrator
  • Member
  • *****
  • Posts: 366
Hi,

It should work. I ran into the issue with the execute button the other day when trying exactly this. Once I figured out my mistake (whoops) with the execute button, it worked fine.

Greetings,
Bootsy

 

SMF spam blocked by CleanTalk