Showcontrol and Pause

[Manu608]

IHello !


I was wondering is there a way to do a pause on a playback and then when a command is send the show will go where we pause it ?!


Thank you

[Bootsy van der Zande]

Hi,

On which device do you want to do this?

On the CueCore2 and QuadCore you can use the task "Playback - Transport - Pause" to pause the cue (and thus track). A simple Go+ (Playback - Transport - Go+) will continue where it left of.

Be careful though, the "Execute" button in ShowControl does not take into account the Triggerflank. Pressing it will do a Go+ twice, so you end up in the next cue...

Using an OSC(or other) command with the Triggerflank set to "Down" or "Up" should work fine.

Greetings,
Bootsy

[Manu608]

Hi

On a quadcore, I will be using UDP signal to do. I couldn't test it yet but  I was wondering if it will work with a transport then a Go+  but i will try it this week and let you know


Thank you

[Bootsy van der Zande]

Hi,

It should work. I ran into the issue with the execute button the other day when trying exactly this. Once I figured out my mistake (whoops) with the execute button, it worked fine.

Greetings,
Bootsy