Visual Productions forum

Author Topic: B-station2 and LPU2 problem  (Read 1684 times)

September 09, 2021, 10:47:46 AM
Read 1684 times

Kulturkvarteret

  • Member
  • *
  • Posts: 1
Hello.
We have lpu2 with 54 RGBW fixtures assigned  that we want to controll from a B-station2. Everthing is connected via an dhcp router and the B-station get Poe from the router. Both the LPU2 and the B-station2 is manageble thru the Vmanager and assigned to the same ip adress. I can control the LPU with the ipad and Cuety but I cant get the B-station to send osc to the LPU. I can se on the monitor that the B-station sends OSC but I dont know how to make the LPU recive OSC.
Does anybody know what I need to check?
ALL the best
fredrik

September 11, 2021, 05:11:41 AM
Reply #1

Julien Levaufre

  • Administrator
  • Member
  • *****
  • Posts: 3229
    • www.visualproductions.nl
you can use the web interface of the LPU2 to check if it is reiceivig the OSC messages.
Compare to B-station the LPU2 cannot be controlled with any osc messages, there is a list of specific commands you need to use to be able to control it.
You can find the list of commands at the end of the cuety manual. (p44)
https://www.visualproductions.nl/downloads/#
Julien Levaufre
Visual Productions BV

 

SMF spam blocked by CleanTalk