Visual Productions forum

Author Topic: B-station2 and LPU2 problem  (Read 854 times)

September 09, 2021, 10:47:46 AM
Read 854 times


  • Member
  • *
  • Posts: 1
We have lpu2 with 54 RGBW fixtures assigned  that we want to controll from a B-station2. Everthing is connected via an dhcp router and the B-station get Poe from the router. Both the LPU2 and the B-station2 is manageble thru the Vmanager and assigned to the same ip adress. I can control the LPU with the ipad and Cuety but I cant get the B-station to send osc to the LPU. I can se on the monitor that the B-station sends OSC but I dont know how to make the LPU recive OSC.
Does anybody know what I need to check?
ALL the best

September 11, 2021, 05:11:41 AM
Reply #1

Julien Levaufre

  • Administrator
  • Member
  • *****
  • Posts: 3087
you can use the web interface of the LPU2 to check if it is reiceivig the OSC messages.
Compare to B-station the LPU2 cannot be controlled with any osc messages, there is a list of specific commands you need to use to be able to control it.
You can find the list of commands at the end of the cuety manual. (p44)
Julien Levaufre
Visual Productions BV


SMF spam blocked by CleanTalk