Visual Productions forum

Author Topic: Fx speed adjust by rotary  (Read 778 times)

September 12, 2021, 07:21:32 AM
Read 778 times


  • Member
  • *
  • Posts: 1
When I make a cue with a fx for the movement of the movingheads and steps for the Ledlights, then when I play the cue and adjust the speed rotary it looks like the fx speed doesn't changes. So when turn the nope to the right my movingheads are moving slow and the led are going very fast.

Is this normal behavior or am I doing something wrong. Because this is very annoying. Now I need to make shows in different speeds.

Thanks in advance.

September 16, 2021, 09:41:07 AM
Reply #1

Bootsy van der Zande

  • Administrator
  • Member
  • *****
  • Posts: 552

I think the rotary only takes one of the two effect speeds to control, but I would have to double check.

Which firmware version are you using on the LPU-1/2? Make sure to upgrade using vManager.



SMF spam blocked by CleanTalk