Hello, we are using the B station for controll studio lights via LPU-2. B station is sending and receiving OSC commands from/to LPU-2, where recalling specific presets. For setup the B station we used the template for LPU-2. Its working, but time to time the B station is showing mitchmatch button lights, What could cause such state? (see the attached video) Only push on/off specific button can reset the button light..
During the system installation we had a problems with ethernet switch security, because of port restriction the b station was not working. After the IT administrator configure the ports, it starts to work, Now we have this problem with button lights,
Thanks for advice.
M.