Visual Productions forum

Author Topic: Artnet Input to Dali Group Output  (Read 43 times)

January 12, 2023, 01:55:12 PM
Read 43 times

fabian.schurtenberger

  • Member
  • *
  • Posts: 2
Hello.

I recently acquired a DaliCore. What i can't figure out is how i can link an ArtNet Address to a Dali Group. I checked the manual but didn't get any wiser. If somebody can point me in the right right direction i would be grateful. Just to be clear: I want from ArtNet input to Dali Group Output.

Thanks a lot for your help.

Kind Regards

Fabian

January 12, 2023, 05:33:37 PM
Reply #1

Julien Levaufre

  • Global Moderator
  • Member
  • *****
  • Posts: 2711
    • www.visualproductions.nl
You need to "program" the DaliCore to tell it what you want to do.

To do that you need to go into the show control tab of the web interface.
AT the bottom left you have the 'templates" list where you can see the "DMX-> Dali groups" template.

Select it and click on add. It will create a "DMX" action list with some actions. You can select each action and click edit to check how it's done.
Once you undersatnd how it work, go back to the show control, add the "art-net" action list from the top left list, and create some actions with the same kind of triggers and task than in the DMX action list.
Then you will be able to control DAlI intensity of groups from Art-net values.

Good luck :)
Julien Levaufre
Visual Productions BV

January 16, 2023, 08:46:52 AM
Reply #2

fabian.schurtenberger

  • Member
  • *
  • Posts: 2
Thanks for your Answer.

That was a help. I will try it as soon as i can.

January 18, 2023, 12:54:32 PM
Reply #3

Julien Levaufre

  • Global Moderator
  • Member
  • *****
  • Posts: 2711
    • www.visualproductions.nl
Julien Levaufre
Visual Productions BV

 

SMF spam blocked by CleanTalk