Dalicore integration

[Mido]

Hi all
I have Art-net lighting system (ip-based) and need to control some dali fixtures through DMX CONTROLLER, I have Dalicore ,  [/b]
PHYSICALLY,  HOW TO CONNECT IT ?
I HAVE.  ART-NET -DMX CONVERTER..
ACTUALLY IAM NEW TO DALI SYSTEM ..
THANKS IN ADVANCE

[Julien Levaufre]

You need to connect your DALI devices to the DALI bus of the DaliCore.
Just Use a basic 2 wires cable to connect the 2 pins from the DAlicore to teh Dali plug of your device.
You will also need to connect a power supply on the Dali Bus, this is a specific power supply done to be used to power up the DALI bus.
This power supply is not done to power up the DaliCore and you cannot use a standard power supply for it.
Connect the Dali PSU like it is a Dali device.
Power on everything, and now you should be able to discover your Dali devices, going into the Dali Patch tab of the DaliCore web interface ( You can use the Vmanager software available on your web site to find the IP address of your DaliCore).
Using the commission button you should be able to patch all your Dali Devices.

enjoy