Visual Productions forum

Author Topic: Timecore keeps running  (Read 204 times)

February 13, 2024, 01:31:58 PM
Read 204 times

TimonDK

  • Member
  • *
  • Posts: 1
Hi all

I am new user, and have just received my Timecore, after updating the firmware the timecore keeps running when the SMPTE source is stop. Is there a way to get the Timecore to stop?

Thanks in advance

Mikkel

February 13, 2024, 04:43:47 PM
Reply #1

Guido Visser

  • Administrator
  • Member
  • *****
  • Posts: 247
    • Visual Productions
Hello Mikkel,

You can configure TimeCore to run for a selectable amount of time after the signal stops.
To do this open the settings page of TimeCore.
And in the section for input there is a Freewheel setting.
You can set this to 2 frames if you want it to stop quickly after a signal loss.

Kind regards,
Guido Visser
Guido Visser
Visual Productions BV

 

SMF spam blocked by CleanTalk