Ecler MIMO88SG with LPU2 (commands)

[Ambassade]

Hi forum members,

I have a Ecler MIMO88SG and i want to integrate with my LPU2.
I've programmed diverent settings but is isnt working yet, has someone a clue?

I used for a button to recall the blackout fuction the string:

|udp|10.100.20.12|7000|blackout=1\n|

I have a other button with different strings:

|udp|10.100.20.12|7000|release\n|
|udp|10.100.20.12|7000|pb01/cue\n|
|udp|10.100.20.12|7000|pb02/cue\n|

pb01 are our front lights, we want to use a the dim function.
So we create two buttoms with a string:
|
udp|10.100.20.12|7000|pb01/in=-10\n|

and

|udp|10.100.20.12|7000|pb01/in=++10\n|

I hope someone sees what i'm doing wrong.

[Julien Levaufre]

Do you see the messages in the LPU-2 monitors?
Could you give it a try removing the /n at the end of each command?

[Ambassade]

I shall remove /n and i've will check the LPU-2 monitoring.
When i will be on site we will try and update this post.

[Julien Levaufre]

Ok, waiting for your feedback.

[Ambassade]

Hi Julien,

i've removed the /n and only the following commands are working so far:

|udp|10.100.20.12|7000|blackout=1
|udp|10.100.20.12|7000|blackout=0

When i want to start a playback it didnt'n work:
|udp|10.100.20.12|7000|pb01/bu

I've i flash a playback it would not flash:
|udp|10.100.20.12|7000|pb01/fl

When i set the playback intensity there is niothing to happen:
|udp|10.100.20.12|7000|pb01/in++10
|udp|10.100.20.12|7000|pb01/in-10

Do you have a clue where i find the solution?

[Joep van Iersel]

It's important that the closing vertical bracket is inserted | Also it seems your integer is missing in the message for the button and flash API message.

For a start of a playback i'd suggest:
|udp|10.100.20.12|7000|pb01/go+|

Set the playback intensity to 10%
|udp|10.100.20.12|7000|pb01/in=10|

Increase the playback with 10%:
|udp|10.100.20.12|7000|pb01/in=++10|

[Ambassade]

Thanks!

The closing vertical bracket was indeed missing.
But the rest didn't work yet ;-)

In the monitor LPU-2 i did not get a output response

i've i send both udp messages below:

|udp|10.100.20.12|7000|pb01/bu=0|
|udp|10.100.20.12|7000|pb01/bu=1|

Then i get differten responses pb02/ac=1  pb02/cue=1 and pb02/cue256 then the playback works.

[Julien Levaufre]

Glad to know that you get some messages working.
What are the messages that are not working now? Can you see the not working messages in the input section of the LPU's monitor?